The installation method of loader axle housing mainly includes the following steps:

Preparation: before installing the axle housing, you need to make sure that the loader is in good working condition, check whether the machine is running normally, whether the lubrication system is normal, and whether the tires are inflated and so on. At the same time, make sure the loader is parked on a smooth ground and set the brakes.

Removing the old axle housing: first, the old axle housing needs to be removed. This usually involves removing the set screws, moving the axle housing to one side using a crane or manpower, and then removing the internal friction plates, brake pads, and other components.

Cleaning and inspection: The disassembled axle housing and parts are meticulously cleaned to ensure that all parts are clean and free of impurities. At the same time, check whether the seals are aged or damaged, and replace them if necessary.

Installation of new bridge shell: Install the new seals in place, making sure that the seals are not deformed or damaged. Then, install the new friction pads and brake linings into the axle housing and apply lubricant to the friction pads.

Assemble the axle housing: Use a crane or other tool to install the new axle housing in place, making sure that the holes between the axle housing and the axle housing are aligned. Then, use screws to secure the axle housing and apply a layer of sealant to the housing to prevent oil leaks.

Safety check: After the installation is complete, carry out a safety check to ensure that all screws have been tightened and there are no oil leaks. Then carry out a test run to ensure that the loader runs smoothly without abnormal noise or vibration.

Through the above steps, you can ensure that the loader axle housing is installed correctly and safely.